Once the holes are drilled I cut along the outside lines of the rectangle with my jig saw and connected the two holes to make one large handle hole in each of the boards. Using a 2 inch forstner bit I drilled 2 holes in each board on the 2 center points I marked on the rectangle that were 1 inch in from the end. These points will act as center marks for the holes that will be drilled I marked a center line horizontally across the rectangle and marked a point 1 inch in from each side. STEP 1: Cut 54 Pieces of 2 x 4 Wood STEP 2: Sand Each Piece Smooth STEP 3: Apply a Coat of Top Coat STEP 4: Cut Out Vinyl Pockets STEP 5: Make Homemade. From the center I measured 3 inches in each direction, marked 2 lines, measured down 4 inches from the top and marked a line across the board, measured 2 inches down from the top and marked another line across.įor the handles I first laid out a rectangle that was centered on each of the side boards 6 inches wide, 2 inches tall, and 2 inches down from the top of the board. Using one hand, take in turns to carefully. Cut the boards to giant Jenga size.For the layout of the handles I first found the center point of both the left and right side boards. Stack the Jenga blocks onto a flat surface in rows of three changing the direction of the blocks for each layer. Tap the plastic threaded pieces into the wood and then thread the feet into place. You can pre-drill them or use a Kreg jig.ĭrill holes to attach self-leveling feet. Attach the frame.Īttach the 2″ x 4″s to one another and then to the board. Cut two boards to 15″ and two boards to 18″ using either a miter saw or a circular saw. Its super simple and easy to make, with no mess All thats needed is a little lumber and sawing, and you got yourself a whole afternoon of Jenga enjoyment.

Make a frame out of the 2″ x 4″s to attach to the plywood. This Giant DIY Jenga Game is family sized and family fun While the little table Jenga is already entertaining enough, this is a great set to play outside with. For this project, cut a square that is 18″ x 18″ out of a 3/4″ plywood. You can use any piece of wood for this one. This project is also a great way to use up left-over material from previous projects and recycle them. I find that a use of a stopper in is a great way to speed up cutting these 10.5- in blocks. Tools:Ī platform is where you will be placing the blocks. When cutting the blocks, take the 2-in x 4-in x 8-ft lumber pieces and cut them into 10.5-in pieces. The size is completely up to you, but I suggest that you keep it below an average person’s height because bigger pieces are heavier and could cause serious injuries. This DIY Giant Jenga Will Change The Way You Play The Gameįor this project, you can use 2″s x 4″s, or even some scrap wood from your previous projects. Our project involved a mix of both new and old wood, seeing as we had a couple that were leftover from our recently finished tool shed.

It took us an entire weekend to get this done. I told my wife about my DIY giant Jenga project and she was ecstatic. A couple of months ago, I watched this Big Bang Theory episode where they played with giant Jenga in their living room, and I was like “Hey! I could do that!”. Using a circular or table saw, cut the five wood boards into 7.5-inch length pieces, which will yield 60 wooden blocks, or 20 stackable rows, for the game. DIY Giant Toppling Tower Plans Jumbo Tumbling Tower game DIY 2x4 lumber Giant Table. It’s a great way to break the ice and it also keeps you thinking. Check out our outdoor jenga selection for the very best in unique or.

Jenga is a family game, mainly because it’s what we play indoors and whenever we have guests around.

Giant jenga diy